Hyundai Santa Fe (DM): Repair procedures
Inspection
| 1. |
Disconnect the ignition switch connector (B) and
key warning switch connector (A) from under the steering column.
|
| 2. |
Check for continuity between the terminals.
|
| 3. |
If continuity is not specified, replace the switch.
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Remove the steering column upper and lower shrouds.
|
| 4. |
Remove the ignition switch (A) after disconnecting
the 6P connector (B).
|
| 5. |
Remove the key warning and immobilizer connector
(A).
|
| 6. |
If it is necessary to remove the key lock cylinder
(A), remove the key lock cylinder with key ACC.
|
Installation
| 1. |
Install the key lock cylinder.
|
| 2. |
Install the key warning and immobilizer connector.
|
| 3. |
Install the ignition switch.
|
| 4. |
Install the steering column shrouds and crash pad
lower panel.
|
See also:
Output Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...
Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use. Your immobilizer system is comprised of a small transponder in the ignition key and ...
Ladder Frame. Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring and hoses to avoid ...
