Hyundai Santa Fe (DM): Rolling code programming
Rolling code devices which are "code-protected" and manufactured after 1996 may be determined by the following:
- Reference the device owner's manual for verification.
- The handheld transmitter appears to program the HomeLink® Universal Transceiver but does not activate the device.
- Press and hold the trained HomeLink button. The device has the rolling code feature if the indicator light flashes rapidly and then turns solid after 2 seconds.
To train rolling code devices, follow these instructions:
1. At the garage door opener receiver (motor-head unit) in the garage, locate
the "learn" or "smart" button. This can usually be found where the hanging antenna
wire is attached to the motor-head unit. Exact location and color of the button
may vary by garage door opener brand. If there is difficulty locating the training
button, reference the device owner's manual or please visit our Web site at www.homelink.com.
2. Firmly press and release the "learn" or "smart" button (which activates the "training
light").
✽ NOTICE
There are 30 seconds in which to initiate step3.
3. Return to the vehicle and firmly press, hold for two seconds and then release
the desired HomeLink® button. Repeat the "press/hold/release" sequence a second
time to complete the programming. (Some devices may require you to repeat this sequence
a third time to complete the programming.)
4. Press and hold the just-trained HomeLink® button and observe the red Status Indicator
LED. If the indicator light stays on constantly, programming is complete and your
device should activate.
5. To program the remaining two HomeLink® buttons, follow either steps 1 through
4 above for other Rolling Code devices or steps 2 through 5 in Standard Programming
for standard devices.
- Gate operator & Canadian programming
- Operating HomeLink
- Reprogramming a single HomeLink® button
- Erasing HomeLink® buttons
- This device complies with Part 15 of the FCC Rules
- Electric chromic mirror (ECM) with HomeLink® system, compass and Blue Link®
- Automatic-dimming function
Standard programming
To train most devices, follow these instructions: 1. For first-time programming, press and hold the two outside buttons, HomeLink® Channel 1 and Channel 3 Buttons, until the indicator light begins to ...Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting. Continue to press the Integrated HomeLink® Wireless Control System button (note steps 2 through 4 in the Standard Programming ...See also:
Repair procedures
Inspection 1. Remove the cowl top cover. 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition ...
Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with foreign matter, ...
To remove the cargo security screen
1. Push in the guide pin. 2. While pushing the lever, pull out the cargo security screen. 3. Open the luggage tray and keep the cargo security screen in the tray. ...