Hyundai Santa Fe (DM): Roof Trim Assembly. Repair procedures - Roof Trim - Body (Interior and Exterior)Hyundai Santa Fe (DM): Roof Trim Assembly. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the third row seat.
2.
Remove the front pillar trim.
3.
Remove the canter pillar upper trim.
4.
Remove the rear pillar trim.
5.
Remove the sunvisor and retainer.
6.
Remove the assist handle.
7.
Remove the overhead console lamp.
8.
Remove the room lamp.
9.
Remove the luggage room lamp.
10.
Tilt the front seat back towards the rear of the vehicle as far as possible.
11.
Fold the second row seat after pushing it towards the front of the vehicle as far as possible.
12.
Remove the ECM mirror cover (A).
13.
Disconnect the ECM mirror connector (B).
14.
Remove the auto defog sensor cover (A).
15.
Disconnect the auto defog sensor connector (B).
16.
Remove the LDWS & rain sensor cover (A).
17.
Disconnect the LDWS connector (A) and rain sensor connector (B).
18.
Disconnect the roof trim main connector (A) and the mounting clips in the front pillar.
[Driver's]

[Passenger's]
19.
Disconnect the roof antenna connector (A) and the mounting clips in the rear pillar.
[RH]
20.
Slighty remove the tail gate weatherstrip.
21.
Slightly lower the rear side of the
22.
To remove the roof trim, press the lock pin (A) in the direction of the arrow.

23.
Detach the clips, then remove the roof trim assembly (A).
•
Take care not to damage the roof trim when removing.

24.
Remove the vanity lamp.
25.
Remove the hands free mic.
26.
Remove roof trim wiring harness (A) from the roof trim (B).
•
Take care not to damage the roof trim wiring harness (A) when removing.

1.
Apply the hot melt continuously when installing the roof trim wiring harness (A) on the roof trim (B) using the hot melt gun tool.
2.
Put anti-noise pad (C) on roof trim (B) to prevent the noise.
27.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Roof Trim Assembly. Components and Components Location
Component Location 1. Roof Trim Assembly ...

Interior Trim
...

See also:

Automatic-dimming function
Your mirror will automatically dim upon detecting glare from the vehicles traveling behind you. The autodimming function can be controlled by pushing the ON/OFF Button: 1. Pressing the button turns the ...

Intake Air Temperature Sensor (IATS). Specifications
Specification Temperature Resistance (kΩ) °C °F -40 -40 40.93 ~ 48.35 -20 -4 13.89 ~ 16.03 0 32 5.38 ~ 6.09 10 50 3.48 ~ 3.90 20 68 2.31 ~ 2.57 40 104 1.08 ~ 1.21 60 140 0.54 ~ 0.62 80 176 0.29 ...

Rear Bumper beam Assembly. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...