Hyundai Santa Fe (DM): Room Lamp. Repair procedures
Inspection
| 1. |
Remove the room lamp assembly then check for continuity
between terminals.
[General]
[Panorama Sunroof]
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Detach the lamp lens (A) from the room lamp with
a flat-tip screwdriver.
|
| 3. |
Replace the room lamp bulb (A).
|
| 4. |
Separate the room lamp (A) from the roof trim after
loosening the screws (2EA).
|
| 5. |
Remove the room lamp (B) after disconnecting the
connector (A).
|
Installation
| 1. |
Install the room lamp assembly after connecting the
lamp connector.
|
| 2. |
Install the lamp lens after assembling the bulb.
|
Turn Signal Lamp. Repair procedures
Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror holder (A) from the outside mirror assembly. Be careful not to damage the fixing clip 3. Remove ...
Overhead Console Lamp. Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. [General] [Panorama Sunroof] Removal ...
See also:
Exterior features
Roof rack If the vehicle has a roof rack, you can load cargo on top of your vehicle. ✽ NOTICE If the vehicle is equipped with a sunroof, be sure not to position cargo onto the roof rack in such ...
Specifications
Specification Items Inner side Outer side Front driveshaft Joint type LSJ 104 UBJ 104 Max. permissible angle 23.5° 46.5° Rear driveshaft Joint type TJ BJ Max. permissible angle 23.5° 46.5° Rear differential ...
Tight corner brake effect
CAUTION - AWD When turning sharply on a paved road at low speed while in all wheel drive, steering control will be difficult. Tight corner brake effect is a unique characteristic of all-wheel drive vehicles ...
