Hyundai Santa Fe (DM): Seat Belt Pretensioner (BPT). Repair procedures
Removal
1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
2. |
Left side - Remove the seat belt lower anchor cover (A). After
loosening the mounting bolt, then remove the seat belt lower anchor
(B).
Аксессуары для бани и сауны товаромания.рф.
Right side - To remove the locking mechanism (A), using a (-)
driver (B) turn it counter clockwise. From the emergency fastening device
(EFD) system (C)
|
3. |
Remove the door scuff trim.
|
4. |
Remove the center pillar trim
|
5. |
Remove the upper anchor bolt.
|
6. |
Loosen the seat belt pretensioner mounting bolts (A,B) and remove
the seat belt pretensioner.
|
7. |
Disconnect the seat belt pretensioner connector (C).
|
Installation
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
3. |
Connect the seat belt pretensioner (BPT) connector (C).
|
4. |
Install the seat belt pretensioner with a bolts (A,B).
|
5. |
Install the upper anchor bolts.
|
6. |
Install the center pillar trim
|
7. |
Install the door scuff trim.
|
8. |
Left side - Install the lower anchor bolts.
Right side - Insert the seat belt to the Emergency fastening device
(A).
|
9. |
Reconnect the battery negative cable.
|
10. |
After installing the seat belt pretensioner, confirm proper system
operation:
|
Emergency Fastening Device (EFD). Description and Operation
Description The Emergency Fastening Device (EFD) operates as well as the belt pretensioner at the same time, if it gets into its deploy condition after a collision. It is located near the anchor on the ...See also:
Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...
Repair procedures
Valve Clearance Inspection And Adjustment Inspect and adjust the valve clearance when the engine is cold (Engine coolant temperature : 20°C (68°F)) and cylinder head is installed on the cylinder block. ...
Knee Airbag (KAB) Module. Components and Components Location
Components ...