Hyundai Santa Fe (DM): Shift Cable. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe (DM): Shift Cable. Repair procedures

Removal

1.
Remove the floor console.
2.
Remove the air duct.
3.
Disconnect the shift cable (A).
4.
Remove the retainer (A) and nut (B).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8~8.7 lb-ft)

5.
Remove the nut (C) from the manual control lever.
Tightening torque:
7.8~11.8 N.m(0.8~1.2 kgf.m, 5.8~8.7 lb-ft)
6.
Remove the cable (B) from the bracket (A) at transaxle assembly side.
7.
Remove the shift cable by pulling it toward the interior.


Installation

1.
Install in the reverse order of removal.
Set shift lever and inhibitor switch manual control lever to "N" position.

Adjustment

Adjusting method for T/M control cable
1.
Set room side shift lever and T/M side manual control lever to "N" position.
2.
Connect room side shift lever and shift cable.
3.
Push cable to "F" direction shown to eliminate FREE PLAY.
4.
Tighten adjusting nut (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8~8.7 lb-ft)

5.
After adjusting according check to be sure that this part operates surely at each range of T/M side corresponding to each position of shift lever.

Shift Cable. Components and Components Location
Components 1. Console upper cover 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

4 Wheel Drive (4WD) System
...

See also:

Propeller Shaft. Components and Components Location
Components 1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...

Inside Rear View Components and Components Location
Component Location 1. Inside rear view mirror ...

Repair procedures
Adjustment 1. After loosening the tail gate hinge (A) mounting bolt, adjust the tail gate by moving it up or down, or right or left. 2. Adjust the tail gate height by turning the tail gate overslam bumpers ...