Hyundai Santa Fe (DM): Shift Lever. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe (DM): Shift Lever. Repair procedures

Removal

1.
Remove the floor console.
2.
Remove the air duct.
3.
Disconnect sports mode connector (A).
4.
Disconnect the shift cable (A).
5.
Remove the shift lever assembly (A) by removing the bolts (C-4ea).
Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)


Installation

1.
Install in the reverse order of removal.
Set shift lever and inhibitor switch manual control lever to "N" position.

Shift Lever. Components and Components Location
Components 1. Console upper cover 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Shift Cable. Components and Components Location
Components 1. Console upper cover 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

See also:

Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram ...

Intake Air Temperature Sensor (IATS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the specification. Specification: ...

Turn Signal Indicator Light
This indicator light blinks: • When you turn the turn signal light on. If any of the following occurs, there may be a malfunction with the turn signal system. In this case, have your vehicle inspected ...