Hyundai Santa Fe (DM): Speakers. Repair procedures - AVN System - Body Electrical SystemHyundai Santa Fe (DM): Speakers. Repair procedures

Inspection

1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector is connected to remove any possible vibration transmitted from body trims and surrounding parts.
https://ae.activeketo-gummies.com active KETO شراء في الإمارات العربية المتحدة.

(2)
Case Troubleshooting
No.
 Case
 Inspection/Remedy
1
 Trembling sound
1.
Before replacing the speaker, inspect that the mounting screw is installed normally.
2.
After re-installing the speaker, verify that no trembling sound is heard.
3.
When hearing a trembling sound again, replace the speaker with new one.
2
 Noise
1.
Check if the wiring connector is connected normally. If not, reconnect the wiring connector.
2.
In case of radio static, check if there is a noise from CD.
3.
When a noise is heard on turning radio and CD on, replace the speaker with new one.
In case there is only radio static, this causes from poor radio reception. Thus the speaker needs no repair and replacement.
3
 Poor working
 Inspection of the wiring connection between the battery and the speaker
1.
Before replacing the speaker, inspect the wiring connection between the battery and the speaker is normal.
2.
Check the supply power to the speaker and the resistance, then inspect the sound quality.
3.
If the speaker works poorly, replace it with new one.

When handling the speaker :
-
Dropping or rough handling of the speaker can cause damage.
-
Be careful not to spill water or oil on the speaker.
-
Caution when dealing with speaker because the diaphragm is paper and can be easily torn by impact and external force.
-
Electrical mishandling of speakers is not covered by manufacturers warranty.

Removal

Front Speaker
1.
Remove the front door trim.
2.
Remove the front speaker (A) after loosening the screws (4EA).
Rear Speaker
1.
Remove the rear door trim.
2.
Remove the rear speaker (A) after loosening the screws (4EA).
Front Center Speaker
1.
Remove the front center speaker grill (A).
2.
Remove the front center speaker (A) after loosening the mounting screws (2EA).
3.
Remove the front center speaker (B) after disconnecting the connector (A).
Tweeter Speaker (Front)
1.
Using a screwdriver or remover, remove the front door quadrant inner cover (A).
2.
Disconnect the tweeter speaker connector (A).
Woofer Speaker
1.
Remove the left luggage side trim.
2.
Disconnect the woofer speaker connector (A).
3.
Remove the woofer speaker (B) after loosening the mounting nuts (2EA) and bolts (2EA).
Rear Surround Speaker
1.
Remove the luggage side trim.
2.
Disconnect the surrond speaker connector (A).
3.
Remove the woofer speaker (B) after loosening the mounting nuts (2EA).

Installation

Front Speaker
1.
Install the front speaker.
2.
Install the front door trim.
Rear Speaker
1.
Install the rear speaker.
2.
Install the rear door trim.
Front Center Speaker
1.
Install the front center speaker.
2.
Install the front center speaker grill.
Tweeter Speaker (Front)
1.
Connect the connector.
2.
Install the tweeter speaker and front door quadrant inner cover
Woofer Speaker
1.
Install the woofer speaker.
2.
Install the left luggage side trim.
Rear Surround Speaker
1.
Install the surround speaker.
2.
Install the luggage side trim.

Multimedia Jack. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the console front complete assembly (A). 3. Remove the multimedia jack (B) after disconnecting the connector (A) from the console front ...

External Amplifier. Components and Components Location
Components Connector Pin Information No. Connector A (26 pin) Connector B (16 pin) Connector C (12 pin) 1 Battery + Right surround speaker + Rear right door + 2 Battery + Left surround speaker + Rear left ...

See also:

Console Armrest. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Luggage Room Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp lens (A) with a flat-tip screwdriver after loosening the screws (2EA). 3. Remove the luggage room lamp bulb (A). ...

Curtain Airbag (CAB) Module. Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by ...