Hyundai Santa Fe (DM): SRS Control Module (SRSCM). Repair procedures
Removal
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Remove the floor console.
|
4. |
Loosen the bolts and then remove the rear air vent duct (A).
|
5. |
Pull up the lock, of the SRSCM connector, then disconnect the
connector (A).
|
6. |
Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove
the SRSCM.
|
You must remove or install SRSCM or other SRS components with
the ignition switch OFF to avoid accidental airbag deployment.
|
Installation
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Install the SRSCM with the SRSCM mounting bolts.
|
4. |
Connect the SRSCM harness connector.
|
5. |
Install the rear air vent duct and floor console.
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the SRSCM, confirm proper system operation:
|
Variant coding
After replacing the SRSCM, the “Variant Coding” must be performed.
|
Variant coding Procedure
■ On-Line type on GDS |
1. |
Ignition "OFF", connect GDS.
|
2. |
Ignition "ON" & Engine "OFF" select vehicle name and airbag system.
|
3. |
Select Variant coding mode.
|
4. |
Follow steps on the screen as below.
|
1) Initial ACU Variant Coding screen
2) VIN Code entering screen
3) Variant coding's proceeding screen-1
4) Variant coding's proceeding screen-2
5) Variant coding is completed
1) This screen is opened when you try the variant coding again
on the SRSCM which has bee performed variant coding.
2) Screen of communication failure
|
■ Off-line type on GDS (This can be used when not connecting to internet)
1) Initial ACU Variant Coding screen
2) ACU Coding Code entering screen
3) Screen of rechecking ACU Coding code's entering
4) Variant coding's proceeding screen-1
5) Variant coding's proceeding screen-2
6) Variant coding is completed
1) This screen is opened when you try the variant coding again
on the SRSCM which has been performed variant coding.
|
Front Impact Sensor (FIS). Description and Operation
Description The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of ...See also:
Seat Heater (Air Ventilation). Schematic
Diagrams
Circuit Diagram ...
Rear Seat Frame Assembly. Repair procedures
Replacement [Second row seat assembly] (LH) • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related ...
Instrument Cluster. Schematic
Diagrams
Circuit Diagram ...