Hyundai Santa Fe (DM): Start/Stop Button. Repair procedures
Removal
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the driver crash pad lower panel.
|
3. |
Disconnect the start/stop button connector (B) after
removing the center fascia garnish (A).
|
4. |
Remove the start/stop button (A) after removing the
screws (3EA).
|
Installation
1. |
Install the start/stop button.
|
2. |
Install the crash pad lower panel.
|
3. |
Connect the negative (-) battery terminal.
|
Start/Stop Button. Components and Components Location
Component ...See also:
26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
ESC Control Module. Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Remove the brake fluid from the master cylinder reservoir with a syringe. • Be sure to completely remove foreign substances from around brake fluid reservoir ...
Head Lamps. Components and Components
Location
Component 1. Head lamp high beam bulb 2. Dust cap (High) 3. Head lamp low beam bulb 4. Dust cap (Low) 5. Turn signal lamp bulb 6. Turn signal lamp socket 7. Side marker bulb 1. Head lamp high beam bulb ...