Hyundai Santa Fe (DM): Starter. Components and Components Location - Starting System - Engine Electrical SystemHyundai Santa Fe (DM): Starter. Components and Components Location

Components

1. Front housing
2. Starter solenoid assembly
3. Lever
4. Lever packing
5. Planet shaft assembly
6. Planetary gear assembly
7. Packing
8. Shield
9. Amature assembly
10. Brush holder assembly
11. Yoke assembly
12. Rear housing
13. Through bolt


Starter. Specifications
Specification Starter Item Specification Rated voltage 12 V, 1.2 kW The number of pinion teeth 11 Performance [No-load, 11 V] Ampere Max. 70 A Speed Min. 2,400 rpm ...

Starter. Schematic Diagrams
Circuit Diagram ...

See also:

Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When ...

Front Disc Brake. Components and Components Location
Components 1. Guide rod bolt 2. Bleed screw 3. Caliper carrier 4. Caliper body 5. Inner pad shim 6. Brake pad 7. Pad retainer ...

Line Pressure Control Solenoid Valve. Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...