Hyundai Santa Fe (DM): Steering Column Shroud Panel. Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Santa Fe (DM): Steering Column Shroud Panel. Repair procedures

Replacement

[Steering column shroud lower panel]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the crash pad lower panel.
2.
After loosening the mounting screws, then remove the steering column shroud lower panel (A).

3.
Install in the reverse order of removal.
•
Replace any damaged clips.
[Steering column shroud upper panel]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Lower the steering wheel.
2.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).

3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Steering Column Shroud Panel. Components and Components Location
Component Location 1. Steering column shroud lower panel 2. Steering column shroud upper panel ...

Crash Pad Side Cover. Components and Components Location
Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

See also:

Fuel Pressure Control Valve. Troubleshooting
Signal Waveform ...

Description and Operation
Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the ...

Injector. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. ...