Hyundai Santa Fe (DM): Tail Gate Latch. Repair procedures - Tail Gate - Body (Interior and Exterior)Hyundai Santa Fe (DM): Tail Gate Latch. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the tail gate trim.
2.
Disconnect the tail gate latch connector (A).
3.
After loosening the mounting bolts, then remove the tail gate latch assembly (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Install in the reverse order of removal.
•
Make sure the tail gate locks/unlocks and opens/closes properly.
•
Adjust the tail gate alignment.
•
Make sure the connectors are connected in properly.

Tail Gate Latch. Components and Components Location
Component Location 1. Tail gate latch assembly ...

Tail Gate Back Panel. Components and Components Location
Component Location 1. Tail gate back panel ...

See also:

To remove the cargo security screen from the luggage tray
1. Pull up the screen board. 2. Push in the guide pin. 3. While pushing the guide pin, pull out the cargo security screen. WARNING Do not place objects on the cargo security screen. Such objects may be ...

Engine compartment
Gasoline 2.4L GDI 1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake fluid reservoir 4. Air cleaner 5. Fuse box 6. Negative battery terminal 7. Positive battery terminal 8. Radiator cap 9. ...

Troubleshooting
Troubleshooting Symptom Suspect area Engine will not start or hard to start Vapor hose damaged or disconnected Engine struggles to start Malfunction of the Purge Control Solenoid Valve Rough idle or engine ...