Hyundai Santa Fe (DM): Torque Converter Control Solenoid Valve (T/CON_VFS). Schematic Diagrams - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe (DM): Torque Converter Control Solenoid Valve (T/CON_VFS). Schematic Diagrams

Hyundai Santa Fe DM 2013-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS). Schematic Diagrams

Circuit Diagram


Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1,1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

See also:

Side Airbag (SAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the front seat assembly. 3. Remove the seat back assembly. The side airbag cannot be disassembled ...

Transaxle Control Module (TCM). Repair procedures
Removal When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used TCM] 1. Perform "TCM Neutral mode" procedure with ...

Cylinder Head Assembly
Components and components location Components 1. Camshaft front bearing cap 2. Camshaft bearing cap 3. OCV & Center bolt 4. Exhaust CVVT assembly 5. Exhaust camshaft 6. Intake camshaft 7. Intake CVVT ...