Hyundai Santa Fe (DM): Trailing Arm. Repair procedures
Removal
1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
Remove the parking brake cable.
|
3. |
Loosen the nuts & bolts and then remove the trailing arm (A) with
the rear axle.
|
4. |
Loosen the mounting bolt and then remove the trailing arm (A)
with the frame.
|
5. |
Installation is the reverse of removal.
|
6. |
Check the rear alignment.
|
Rear Coil Spring. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...Rear Assist Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...See also:
Head Lamps. Repair procedures
Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. ...
Main Crash Pad Assembly. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Direct Electro Hydraulic Actuator Coupling. Repair procedures
Inspection All units are filled up with coupling fluid (ultra-low viscosity ATF) prior to shipping. Inspection, fill-up, and replacement of coupling fluid is therefore not necessary (zero maintenance, ...