Hyundai Santa Fe (DM): Transmitter precautions - Folding key - Features of your vehicleHyundai Santa Fe (DM): Transmitter precautions

✽ NOTICE

The transmitter will not work if any of following occur:

  • The ignition key is in the ignition switch.
  • You exceed the operating distance limit (about 90 feet [30 m]).
  • The battery in the transmitter is weak.
  • Other vehicles or objects may be blocking the signal.
  • The weather is extremely cold.
  • The transmitter is close to a radio transmitter such as a radio substation or an airport which can interfere with normal operation of the transmitter.

When the transmitter does not work correctly, open and close the door with the ignition key. If you have a problem with the transmitter, contact an authorized HYUNDAI dealer.

• If the transmitter is in close proximity to your mobile phone, the signal could be blocked by your mobile phones normal operational signals. This is especially important when the phone is active such as making and receiving calls, text messaging, and/or sending/receiving emails. Avoid placing the transmitter and your mobile phone in the same pants or jacket pocket and always try to maintain an adequate distance between the two devices.

CAUTION

Keep the transmitter away from water or any liquid. If the keyless entry system is inoperative due to exposure to water or liquids, it will not be covered by your manufacturer’s vehicle warranty.

Key operations
Used to start the engine. Used to lock and unlock the doors. Used to lock and unlock the glove box. To unfold the key, press the release button then the key will unfold automatically. To fold the key, ...

Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gently pry ...

See also:

Jump starting procedure
✽ NOTICE If the battery is discharged, the engine can be started using a battery of another vehicle and two jumper cables. Only use jumper cables with fully insulated clamp handles. To prevent personal ...

Yaw-rate and G Sensor. Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. 4. Loosen the bolts ...

Variable Intake Solenoid (VIS) Valve. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance between VIS valve terminals 1 and 2. Specification: Refer to "Specification" Removal 1. ...