Hyundai Santa Fe (DM): Troubleshooting
Troubleshooting
| Problem Symptoms Table |
Use the table below to help you find the cause of the problem. The numbers
indicate the priority of the like cause of the problem. Check each part in order.
If necessary, replace these parts.
|
Symptom |
Suspect Area |
Reference |
|
Lower pedal or spongy pedal |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Piston seals (Worn or damaged) 4. Rear brake shoe clearance(Out of adjustment) 5. Master cylinder (Inoperative) |
repair air·bleed replace adjust replace |
|
Brake drag |
1. Brake pedal free play (Minimum) 2. Parking brake lever travel (Out of adjustment) 3. Parking brake wire (Sticking) 4. Rear brake shoe clearance(Out of adjustment) 5. Pad or lining (Cracked or distorted) 6. Piston (Stuck) 7. Piston (Frozen) 8. Anchor or shoe (Inoperative) 9. Booster system (Vacuum leaks) 10. Master cylinder (Inoperative) |
adjust adjust repair adjust replace replace replace replace repair replace |
|
Brake pull |
1. Piston (Sticking) 2. Pad or lining (Oily) 3. Piston (Frozen) 4. Disc (Scored) 5. Pad or lining (Cracked or distorted) |
replace replace replace replace replace |
|
Hard pedal but brake inefficient |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Pad or lining (Worn) 4. Pad or lining (Cracked or distorted) 5. Rear brake shoe clearance(Out of adjustment) 6. Pad or lining (Oily) 7. Pad or lining (Glazed) 8. Disc (Scored) 9. Booster system (Vacuum leaks) |
repair air·bleed replace replace adjust adjust replace replace repair |
|
Noise from brake |
1. Pad or lining (Cracked or distorted) 2. Installation bolt (Loosen) 3. Disc (Scored) 4. Sliding pin (Worn) 5. Pad or lining (Dirty) 6. Pad or lining (Glazed) 7. Anchor or shoe (Faulty) 8. Brake pad shim (Damage) 9. Shoe hold-down spring (Damage) |
replace adjust replace replace clean replace replace replace replace |
|
Brake fades |
1. Master cylinder (Inoperative) |
replace |
|
Brake vibration, pulsation |
1. Brake booster (Vacuum leaks) 2. Pedal free play 3. Master cylinder (Inoperative) 4. Caliper (Damage) 5. Master cylinder cap seal 6. Damaged brake lines |
replace adjust replace replace replace replace |
|
Brake Chatter |
Brake chatter is usually caused by loose or worn components, or glazed
or burnt linings. Rotors with hard spots can also contribute to brake chatter.
Additional causes of chatter are out-of-tolerance rotors, brake lining not
securely attached to the shoes, loose wheel bearings and contaminated brake
lining. |
|
Special Service Tools
Special Service Tools Tool(Number and Name) Illustration Use 09581-11000 Piston expander Spreading the front disc brake piston. ...
Brake System
...
See also:
Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window opening and closing ...
Front Seat Shield Outer Cover. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Repair procedures
Operation and Leakage Check Check all of the following items: Component Procedure Brake Booster (A) Check brake operation by applying the brakes during a test drive. If the brakes do not work properly, ...
