Hyundai Santa Fe (DM): Turn Signal Lamp. Repair procedures
Removal
Door Mirror Turn Signal Lamp
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the mirror holder (A) from the outside mirror
assembly.
|
| 3. |
Remove the door mirror housing (A) after loosening
a screw.
|
| 4. |
Remove the door mirror cover (A).
|
| 5. |
Loosen the mirror turn signal lamp mounting screw.
|
| 6. |
Remove the door mirror turn signal lamp (B) after
disconnecting the connector (A).
|
Installation
Door Mirror Turn Signal Lamp
| 1. |
Install the door mirror turn signal lamp.
|
| 2. |
Install the door mirror cover and housing.
|
| 3. |
Install the door mirror.
|
| 4. |
Connect the negative (-) battery terminal.
|
Head Lamps. Repair procedures
Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. ...
Room Lamp. Repair procedures
Inspection 1. Remove the room lamp assembly then check for continuity between terminals. [General] [Panorama Sunroof] Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) ...
See also:
Troubleshooting
Fault Diagnosis Features a fail-safe mechanism that provides "limp-home" 4th gear hold to enable the vehicle to be driven to the owner's home or dealer shop. Fail-Safe: The TCM provides 4th ...
Alternator. Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable from alternator "B" terminal (C). 3. ...
Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...
