Hyundai Santa Fe (DM): Water Temperature Control Assembly. Components and Components 
Location - Cooling System - Engine Mechanical SystemHyundai Santa Fe (DM): Water Temperature Control Assembly. Components and Components Location

Components

1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant hose


Reservoir Tank. Repair procedures
Removal and Installation 1. Remove the over flow hose(A). 2. Remove the reservoir tank(B). Tightening torque: 7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft) 3. Install in the reverse order of removal. ...

Water Temperature Control Assembly. Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Loosen the drain plug and drain the engine coolant. 3. Remove the radiator upper hose and lower hose. 4. Disconnect the connectors and then remove ...

See also:

Driving on grades
Reduce speed and shift to a lower gear before you start down a long or steep downgrade. If you don’t shift down, you might have to use your brakes so much that they would get hot and no longer operate ...

Automatic transaxle
Depress the brake pedal and the lock release button when shifting. (If the shift lock system is not equipped, it is not necessary to depress the brake pedal. However, it is recommended to depress the ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...