Hyundai Santa Fe (DM): Yaw-rate and G Sensor. Repair procedures
Removal
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Remove the floor console.
|
4. |
Loosen the bolts and then remove the rear air vent duct (A).
|
5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A).
|
6. |
Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove
the SRSCM.
|
You must remove or install SRSCM or other SRS components with
the ignition swich OFF to avoid accidental airbag deployment.
|
Installation
1. |
Remove the ignition key from the vehicle.
|
2. |
Install inthe reverse order of removal.
|
3. |
After installing the SRSCM, confirm proper system operation:
|
G-Sensor Calibration
1. |
Ignition "OFF", connect GDS.
|
2. |
Ignition "ON" & Engine "OFF" select vehicle name and ESP system.
|
3. |
Perform G-sensor calibration.
|
4. |
Perform the " G-Sensor Calibration " procedure with GDS.
|
5. |
Complete the “G-Sensor Calibration” procedure.
|
Yaw-rate and G Sensor. Description and Operation
Description The yaw rate and G sensor is included inside the air bag control module (SRSCM). When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly ...ESC OFF Switch. Description and Operation
Description 1. The ESC OFF switch is for the user to turn off the ESC system. 2. The ESC OFF lamp is on when ESC OFF switch is engaged. ...See also:
Master Cylinder. Components and Components Location
Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...
Engine start/stop button position
OFF White With automatic transaxle To turn off the engine (START/RUN position) or vehicle power (ON position), press the engine start/stop button with the shift lever in the P (Park) position. When you ...
Hood Latch Release Handle. Components and Components Location
Component Location 1. Hood latch release handle ...