Hyundai Santa Fe: Door Mood Lamp. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
|
| 3. |
Disconnect the door mood lamp connectors (A).
|
| 4. |
Remove the door mood lamp (A) after loosening the
screws (3EA).
|
| 5. |
If it is necessary to replace the bulb, replace the
bulb (A) after disconnecting the connector.
|
Installation
| 1. |
Install the door mood lamp and connector.
|
| 2. |
Install the front door trim.
|
| 3. |
Connect the negative (-) battery terminal.
|
Overhead Console Lamp. Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. [General] [Panorama Sunroof] Removal ...
Hazard Lamp Switch. Repair procedures
Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of hazard lamp switch ...
See also:
Low tire pressure indicator
When the tire pressure monitoring system warning indicator is illuminated, one or more of your tires is significantly under-inflated. If the indicator illuminates, immediately reduce your speed, avoid ...
Front Washer Motor. Repair
procedures
Inspection Front and Rear Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign ...
Engine Control Module (ECM). Schematic Diagrams
ECM Terminal And Input/Output signal ECM Terminal Function Connector [C100-A] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output [NON-smart key type] Ignition Coil (Cylinder ...
