Hyundai Santa Fe: Height adjustment (Front) - Seat belt restraint system - Seat belts - Safety features of your vehicle - Hyundai Santa Fe DM 2013-2019 Owner's ManualHyundai Santa Fe: Height adjustment (Front)

You can adjust the height of the shoulder belt anchor to one of 4 positions for

You can adjust the height of the shoulder belt anchor to one of 4 positions for maximum comfort and safety.

The shoulder portion should be adjusted so that it lies across your chest and midway over your shoulder nearest the door and not your neck.

The height of the adjusting seat belt should not be too near your neck.

To adjust the height of the seat belt anchor, lower or raise the height adjuster into an appropriate position. To raise the height adjuster, pull it up (1). To lower it, push it down (3) while pressing the height adjuster button (2).

Release the button to lock the anchor into position. Try sliding the height adjuster to make sure that it has locked into position.

WARNING

  • Verify the shoulder belt anchor is locked into position at the appropriate height. Never position the shoulder belt across your neck or face. Improperly positioned seat belts can cause serious injuries in an accident.
  • Failure to replace seat belts after an accident could leave you with damaged seat belts that will not provide protection in the event of another collision leading to personal injury or death. Replace your seat belts after being in an accident as soon as possible.

WARNING

WARNING

You should place the lap belt portion as low as possible and snugly across your hips, not on your waist. If the lap belt is located too high on your waist, it may increase the chance of injury in the event of a collision. Both arms should not be under or over the belt. Rather, one should be over and the other under, as shown in the illustration.

Never wear the seat belt under the arm nearest the door.

    Seat belt - Driver's 3-point system with emergency locking retractor
    To fasten your seat belt: To fasten your seat belt, pull it out of the retractor and insert the metal tab (1) into the buckle (2). There will be an audible "click" when the tab locks in ...

    Seat belts - Front passenger and rear seat 3-point system with combination locking retractor
    To fasten your seat belt: Combination retractor type seat belts are installed in the rear seat positions to help accommodate the installation of child restraint systems. Although a combination re ...

    See also:

    TPMS Receiver. Schematic Diagrams
    System Circuit Diagram No Function 1 MCU part 2 CAN interface part 3 5V supply part ...

    Removing and storing the spare tire
    Your spare tire is stored underneath your vehicle, directly below the cargo area. To remove the spare tire: 1. Open the tailgate. 2. Find the plastic hex bolt cover and remove the cover with co ...

    SRS components and functions
    The SRS consists of the following components: 1. Driver's front air bag module 2. Passenger's front air bag module 3. Side impact air bag modules 4. Curtain air bag modules 5. Retractor ...