Hyundai Santa Fe: Hood Latch Release Handle. Repair procedures - Hood - Body (Interior and Exterior)Hyundai Santa Fe: Hood Latch Release Handle. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle. Repair procedures

Replacement

1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.

2.
Install in the reverse order of removal.
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.

Hood Latch Release Handle. Components and Components Location
Component Location 1. Hood latch release handle ...

Hood Latch. Components and Components Location
Component Location 1. Hood upper latch assembly 2. Hood lower latch assembly ...

See also:

Fuel Filler Door Open Switch. Repair procedures
Inspection 1. Remove the front door trim. 2. Disconnect the switch connector (A) from wiring. 3. Check the switch for continuity between the No. 1 and No. 2 terminals. If the continuity is not as specified, ...

Repair procedures
Operation and Leakage Check Check all of the following items: Component Procedure Brake Booster (A) Check brake operation by applying the brakes during a test drive. If the brakes do not work properly, ...

Balance Shaft & Oil Pump. Repair procedures
Removal 1. Remove the timing chain. 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. Remove the balance shaft chain hydraulic tensioner (B). 4. Remove the balance shaft ...