Hyundai Santa Fe: Hood Seal Weatherstrip. Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Santa Fe DM 2013-2019 Service ManualHyundai Santa Fe: Hood Seal Weatherstrip. Repair procedures

Replacement

1.
Detach the clips, then remove the hood seal weatherstrip (A).
Be careful not to scratch the hood seal weatherstrip.

2.
Install in the reverse order of removal.
Replace any damaged clips.

    Hood Insulator Pad. Repair procedures
    Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). ...

    Hood Weatherstrip. Repair procedures
    Replacement 1. Remove the hood weatherstrip (A). ...

    See also:

    Inhibitor Switch. Description and Operation
    Description Inhibitor Switch monitors the lever's position(P, R, N, D) and is used to control gear setting signals. ...

    All Wheel Drive (AWD) Warning Light
    This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is ...

    Reprogramming a single HomeLink button
    To program a new device to a previously trained HomeLink button, follow these steps: 1. Press and hold the desired HomeLink button. Do NOT release until step 4 has been completed. 2. When the ...