Hyundai Santa Fe: Knee Airbag (KAB) Module. Repair procedures - Airbag Module - RestraintHyundai Santa Fe: Knee Airbag (KAB) Module. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / Airbag Module / Knee Airbag (KAB) Module. Repair procedures

Removal

1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the crash pad lower panel.
3.
After loosening the mounting nuts and then remove the knee airbag (A).
4.
Disconnect the knee airbag harness connector.

Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Connect the knee airbag connector.
4.
Tighten the knee airbag mounting nuts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
5.
Install the crash pad lower panel.
6.
Install the crash pad side cover.
7.
Reconnect the battery negative cable.
8.
After installing the knee airbag, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Knee Airbag (KAB) Module. Components and Components Location
Components ...

Airbag Module Disposal. Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags must be ...

See also:

Seat Belt Pretensioner (BPT). Components and Components Location
Components ...

Compass function
The Compass can be turned ON and OFF and will remember the last state when the ignition is cycled. To turn the display feature ON/OFF: 1. Press and release the button within 1 second to turn the display ...

Speakers. Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector is connected ...