Hyundai Santa Fe: License plate lamp bulb replacement - High mounted stop lamp replacement - Light bulbs - MaintenanceHyundai Santa Fe: License plate lamp bulb replacement

1. Loosen the lens retaining screws with a screwdriver.

1. Loosen the lens retaining screws with a screwdriver.
2. Remove the lens.
3. Remove the bulb.
4. Install a new bulb.
5. Reinstall the lens securely with the lens retaining screws.

    High mounted stop lamp replacement
    1.Open the tailgate. 2.Gently remove the center cover of the rear tailgate trim. 3.Disconnect the electrical connector. 4.Loosen the retaining nuts and remove the spoiler. 5.Remove ...

    Interior lamp bulb replacement
    WARNING Prior to working on the Interior Lamps, ensure that the “OFF” button is depressed to avoid burning your fingers or receiving an electric shock. 1. Using a flat-blade screwdriver, gen ...

    See also:

    Driving in flooded areas
    Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

    Spark Plug. Repair procedures
    Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm 3 times or more. 2. Remove the spark plug. ...

    Injector. Troubleshooting
    Signal Waveform ...