Hyundai Santa Fe: Luggage Room Lamp. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the luggage room lamp lens (A) with a flat-tip
screwdriver after loosening the screws (2EA).
|
| 3. |
Remove the luggage room lamp bulb (A).
|
| 4. |
Remove the luggage room lamp assembly (A) after disconnecting
the connector.
|
| 5. |
If it is necessary to replace the bulb, replace the
luggage room lamp bulb.
|
Installation
| 1. |
Install the luggage room lamp assembly after connecting
the lamp connector.
|
High Mounted Stop Lamp. Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the rear spoiler. 3. Remove the high mounted stop lamp assembly (A) after loosening screws (4EA). Installation ...
Rear Combination Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the screws (2EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination lamp (B). ...
See also:
Battery Sensor. Repair procedures
Removal 1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remove the battery negative (-) cable after removing the bolts (B). Installation 1. Install in the ...
Fuel Pressure Control Valve. Troubleshooting
Signal Waveform ...
Crash Pad Side Cover. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
