Hyundai Santa Fe: Lumbar support (for driver’s seat)
1. Press the front portion of the switch to increase support or the rear portion
of the switch to decrease support.
2. Release the switch once it reaches the desired position.
Seat cushion height (for driver’s seat)
To change the height of the seat cushion, push the lever upwards or downwards. To lower the seat cushion, push the lever down several times. To raise the seat cushion, pull the lever up several times. ...
Front seat adjustment - Power
The front seat can be adjusted by using the control knobs located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, ...
See also:
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow extra distance for braking. Avoid sudden ...
Line Pressure Control Solenoid Valve. Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Road warning
Hazard warning flasher Type A Type B The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used ...
