Hyundai Santa Fe: Malfunction Indicator Lamp (MIL) - Warning lights - Warning and indicator sights - Features of your vehicleHyundai Santa Fe: Malfunction Indicator Lamp (MIL)

This warning light illuminates:

This warning light illuminates:

  • Once you set the ignition switch or Engine Start/Stop Button to the ON position.
    - It remains on until the engine is started.
  • When there is a malfunction with the emission control system.
    In this case, have your vehicle inspected by an authorized HYUNDAI dealer.

CAUTION - Malfunction Indicator Lamp (MIL)

Driving with the Malfunction Indicator Lamp (MIL) on may cause damage to the emission control systems which could effect drivability and/or fuel economy.

CAUTION - Gasoline Engine

If the Malfunction Indicator Lamp (MIL) illuminates, potential catalytic converter damage is possible which could result in loss of engine power. In this case, have your vehicle inspected by an authorized HYUNDAI dealer as soon as possible.

    Electronic Power Steering (EPS) Warning Light
    This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with ...

    Charging System Warning Light
    This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with ...

    See also:

    Gate operator & Canadian programming
    During programming, your handheld transmitter may automatically stop transmitting. Continue to press the Integrated HomeLinkВ® Wireless Control System button (note steps 2 through 4 in the Standar ...

    Rear Door Belt Outside Weatherstrip. Repair procedures
    Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, then re ...

    ICM (Integrated Circuit Module) Relay Box. Repair procedures
    Inspection Rear Blower Motor relay Check for continuity between the terminals. 1. There should be continuity between the No.16 and No.15 terminals when power and g ...