Hyundai Santa Fe: Oil hydraulic Motor(Actuator). Description and Operation - Coupling Assembly - 4 Wheel Drive (4WD) SystemHyundai Santa Fe: Oil hydraulic Motor(Actuator). Description and Operation

Description

The 4WD ECM controls the Pump Motor Pump (Actuator) to generating an oil pressure. The pressure engages a multiple disk clutch to transfer torque to the rear wheels. The torque to the rear wheels varies according to the pressure on the clutch.


    Direct Electro Hydraulic Actuator Coupling. Repair procedures
    Inspection All units are filled up with coupling fluid (ultra-low viscosity ATF) prior to shipping. Inspection, fill-up, and r ...

    See also:

    Wheel. Repair procedures
    Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

    Windshield wipers
    Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever ...

    Troubleshooting
    Troubleshooting Symptom Suspect Area Remedy (Refer to page) Water leaks from panorama sunroof Deteriorated roof lid weatherstrip ...