Hyundai Santa Fe (DM): Coupling Assembly
OFF mode Illuminated engine start/stop button Driver Airbag (DAB) Module and Clock Spring. Repair procedures
Replacement 1. Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool. 2. Disconnect the battery negative cable from the battery 3. Disconnect the 4WD ECU connector (A). ...
4WD ECU. Repair procedures
Component Location 1. Coupling assembly 2. Propeller shaft 3. Transfer assembly Components 1. Coupling assembly 2. Input shaft 3. Pressure sensor 4. Extension wiring 5. Oil hydraulic Motor(Actuator) ...
Direct Electro Hydraulic Actuator Coupling. Components and Components LocationSee also:
Push the OFF button to turn off the air climate control system. However, you can still operate the mode and air intake buttons as long as the ignition switch is in the ON position. ...
Whenever the front door is opened, the engine start/stop button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. It will also go off immediately ...
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module by putting in a flat tool (Ø5mm) into the guide hole ...
