Hyundai Santa Fe: Oil Seal. Repair procedures - Transfer Assembly - 4 Wheel Drive (4WD) SystemHyundai Santa Fe: Oil Seal. Repair procedures

Replacement

[Right side]
1.
Remove the driveshaft assembly. (RH side)
2.
Remove the dust cover (A).
3.
Remove the oil seal (A, B).
4.
Install the oil seal with special service tools.
•
Apply lithium type grease between seal lips.
•
Use the oil seal installer (09473-3B100) after removing the coupling (A).

5.
Install the new dust cover (A).
6.
Add to transfer fluid.
7.
Install the drive shaft assembly. (RH side)
[Left side]
1.
Remove the transfer assembly from the transaxle assembly.
2.
Remove the oil seal (A).
3.
Install the oil seal with special service tools.
•
Apply lithium type grease between seal lips.
Use the oil seal installer (09473-3B100) after removing the coupling (A).

4.
Add to transfer fluid.
5.
Install the transfer assembly.

Front Wheel Repair procedures
Removal 1. Remove the driveshaft and axle. 2. Remove the propeller shaft (A). Tightening torque : 49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft) 3. Loosen the transfer upper & lower mounting bolts. (transfer ...

4WD Control System
...

See also:

Cooling Fan. Schematic Diagrams
Circuit Diagram PWM Circuti Diagram ...

Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use. Your immobilizer system is comprised of a small transponder in the ignition key and ...

ETC (Electronic Throttle Control) System. Description and Operation
Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator ...