Hyundai Santa Fe: Propeller Shaft Assembly
Engine Control Module (ECM). Repair procedures Vehicle certification label Intake Manifold. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...
Rear Driveshaft. Repair procedures
Components 1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...
Propeller Shaft. Components and Components LocationSee also:
Removal When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with ...
The vehicle certification label attached on the driver’s side center pillar gives the vehicle identification number (VIN). ...
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the air cleaner assembly. 3. Disconnect the intake OCV (Oil control valve) connector (A). 4. Disconnect the VIS (Variable ...
