Hyundai Santa Fe: Rear Door Inside Handle. Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Santa Fe: Rear Door Inside Handle. Repair procedures

Replacement

1.
Remove the rear door trim.
2.
After loosening the mounting screws, then remove the rear door inside handle (A).
3.
Install in the reverse order of removal.
•
Make sure the door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.

Rear Door Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Rear Door Window Glass. Components and Components Location
Component Location 1. Rear door window glass ...

See also:

Rear Center Seat Belt Retractor. Repair procedures
Replacement • When installing the belt, make sure not to damage the retractor. 1. Remove the second row seat back cover [LH]. 2. Loosen the rear center seat belt lower anchor mounting bolt (A). Tightening ...

In the event of brake failure
If service brakes fail to operate while the vehicle is in motion, you can make an emergency stop with the parking brake. The stopping distance, however, will be much greater than normal. WARNING - Parking ...

Valve Body. Repair procedures
Removal 1. Remove the air duct. 2. Remove the battery and the battery tray. 3. Remove the under cover(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Drain the coolant. 5. ...