Hyundai Santa Fe: Room Lamp. Repair procedures
Inspection
| 1. |
Remove the room lamp assembly then check for continuity
between terminals.
[General]
[Panorama Sunroof]
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Detach the lamp lens (A) from the room lamp with
a flat-tip screwdriver.
|
| 3. |
Replace the room lamp bulb (A).
|
| 4. |
Separate the room lamp (A) from the roof trim after
loosening the screws (2EA).
|
| 5. |
Remove the room lamp (B) after disconnecting the
connector (A).
|
Installation
| 1. |
Install the room lamp assembly after connecting the
lamp connector.
|
| 2. |
Install the lamp lens after assembling the bulb.
|
Turn Signal Lamp. Repair procedures
Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror holder (A) from the outside mirror assembly. Be careful not to damage the fixing clip 3. Remove ...
Overhead Console Lamp. Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. [General] [Panorama Sunroof] Removal ...
See also:
Alternator. Specifications
Specification Alternator Item Specification Rated voltage 13.5V, 130A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Refer to below ...
Ignition switch position
LOCK The steering wheel locks to protect against theft. The ignition key can be removed only in the LOCK position. When turning the ignition switch to the LOCK position, push the key inward at the ACC ...
Side Sill Molding. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
