Hyundai Santa Fe: Turn Signal Lamp. Repair procedures
Removal
Door Mirror Turn Signal Lamp
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the mirror holder (A) from the outside mirror
assembly.
|
| 3. |
Remove the door mirror housing (A) after loosening
a screw.
|
| 4. |
Remove the door mirror cover (A).
|
| 5. |
Loosen the mirror turn signal lamp mounting screw.
|
| 6. |
Remove the door mirror turn signal lamp (B) after
disconnecting the connector (A).
|
Installation
Door Mirror Turn Signal Lamp
| 1. |
Install the door mirror turn signal lamp.
|
| 2. |
Install the door mirror cover and housing.
|
| 3. |
Install the door mirror.
|
| 4. |
Connect the negative (-) battery terminal.
|
Head Lamps. Repair procedures
Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. ...
Room Lamp. Repair procedures
Inspection 1. Remove the room lamp assembly then check for continuity between terminals. [General] [Panorama Sunroof] Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) ...
See also:
Spark Plug. Specifications
Specification Item Specification Type FXU16HR11 Gap 1.0 ~1.1 mm (0.0394 ~ 0.0433 in.) ...
Rear Seat Assembly. Repair procedures
Replacement [Second row seat assembly] 1. Push the second row seat assembly [RH] (A) towards the front of the vehicle as far as possible. 2. Loosen the second center seat belt buckle mounting bolt (A). ...
Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) ...
