Hyundai Santa Fe: Side Impact Sensor (SIS). Description and Operation
Description
Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor
(P-SIS) which are installed at each center of the front door module (LH and
RH) and two SIS which are installed at each center pillar nearby (LH and RH)
and two rear SIS which are installed in the rear pillar (LH and RH).
Pressure Side Impact Sensor is also called P-SIS because it detects pressure
due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.
SRSCM decides deployment of the airbag and the time of deployment through
the collision signal of the SIS when the collision occurred.
Front Impact Sensor (FIS). Repair procedures
Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor connector, disconnect the front airbag ...
Side Impact Sensor (SIS). Components and Components Location
Components ...
See also:
Rear Differential Carrier. Components and Components Location
Component 1. Rear Differential Carrier 2. Coupling Assembly ...
Timing Chain Cover. Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. Mark all wiring and hoses to avoid misconnection. ...
Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted when the ...
