Hyundai Santa Fe: 26 Brake Control Solenoid Valve(26/B_VFS). Schematic Diagrams - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: 26 Brake Control Solenoid Valve(26/B_VFS). Schematic Diagrams

Hyundai Santa Fe DM 2013-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS). Schematic Diagrams

Circuit Diagram


26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1, 1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...

26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

See also:

Refrigerant label
The refrigerant label is located at the front of the engine room. ...

Repair procedures
Replacement 1. Remove the cap (A) and remove the nuts, then remove the wiper arm (B). Tightening torque : 22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft) 2. Detach the clips, then remove the fender ...

Trailer brakes
If your trailer is equipped with a braking system, make sure it conforms to federal and/or local regulations and that it is properly installed and operating correctly. If your trailer weight exceeds the ...