Hyundai Santa Fe (TM): If the engine will not start
- Be sure to shift the gear to N (Neutral) or P (Park). The engine starts only when the gear is in N (Neutral) or P (Park).
- Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is drained. See instructions for “Jump Starting” provided in this chapter.
- Check the fuel level and add fuel if necessary.
If the vehicle still does not start, we recommend that you call an authorized HYUNDAI dealer for assistance.
NOTICE
Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.
In case of an emergency while driving
If the engine stalls while driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher. Try to start the engine again. ...
Jump starting
Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt about how to properly jump start your ...
See also:
Front Seat Shield Outer Cover. Components and Components Location
Component Location 1. Front seat shield outer cover ...
Rear Door Latch. Repair procedures
Replacement 1. Remove the rear door module. 2. Remove the rear door outside handle base (A) by pushing in the lock pins located in the back. 3. Remove the rear door outside handle base cable (A). 4. Open ...
Cylinder Block
Drive Plate. Repair procedures Removal and Installation • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising ...
