Hyundai Santa Fe (DM): Accelerator Position Sensor (APS). Specifications
Specification
|
Accelerator Position |
Output Voltage (V) |
|
|
APS1 |
APS2 |
|
|
C.T |
0.7 ~ 0.8 |
0.275 ~ 0.475 |
|
W.O.T |
3.8 ~ 4.4 |
1.75 ~ 2.35 |
Accelerator Position Sensor (APS). Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...
Accelerator Position Sensor (APS). Schematic Diagrams
Circuit Diagram ...
See also:
Master Cylinder. Repair procedures
Removal 1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly. 3. Disconnect the brake fluid level switch connector (B), and remove the reservoir ...
Rear Door Latch. Repair procedures
Replacement 1. Remove the rear door module. 2. Remove the rear door outside handle base (A) by pushing in the lock pins located in the back. 3. Remove the rear door outside handle base cable (A). 4. Open ...
Components and Components Location
Components 1. Front pillar trim 2. Center pillar lower trim 3. Center pillar upper trim 4. Rear pillar trim 5. Cowl side trim 6. Front door scuff trim 7. Rear door scuff trim 8.Front door step trim 9. ...
