Hyundai Santa Fe: Audio Remote Control. Repair procedures - Audio - Body Electrical SystemHyundai Santa Fe: Audio Remote Control. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body Electrical System / Audio / Audio Remote Control. Repair procedures

Inspection

1.
Check for resistance between terminals in each switch position.

[Audio]
Switch
 Connector
terminal
 Resistance
(± 5%)
SEEK up
 2-7
 430 Ω
SEEK down
 2-7
 1.11 kΩ
Mode
 2-7
 2.11 kΩ
Mute
 2-7
 3.11 kΩ
Volume up
 2-7
 4.61 kΩ
Volume down
 2-7
 6.81 kΩ

[Cruise + Flex]
Switch
 Connector
terminal
 Resistance
(± 5%)
CANCEL
 2-7
 180 Ω
RES +
 2-7
 330 Ω
SET -
 2-7
 550 Ω
Cruise ON/OFF
 2-7
 880 Ω
Limit
 2-7
 1.44 kΩ
Flex
 2-7
 5.56 kΩ

[Bluetooth + Voice]
Switch
 Connector
terminal
 Resistance
(± 5%)
Voice
 2-5
 3.9 kΩ
End
 2-5
 12.1 kΩ
Send
 2-5
 34.1 kΩ

[Trip]
Switch
 Connector
terminal
 Resistance
(± 5%)
Group
 2-5
 330 Ω
Trip
 2-5
 550 Ω
Select/Reset
 2-5
 880 Ω


Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
3.
Remove the steering wheel.
4.
Remove the steering wheel cover (A) after loosening the screws.
5.
Loosen the screws after disconnecting the steering wheel remote control switch connector (A).
6.
Remove the remote control switchs (A).

Installation

1.
Install the remote control switch on the steering wheel.
2.
Install the steering wheel.
3.
Reconnect the remote control switch connector and airbag connectors.
Make sure that the switch connector is plugged in properly.
4.
Install the driver airbag module.
5.
Connect the negative (-) battery terminal.

Audio Remote Control. Schematic Diagrams
Circuit Diagram ...

AUX(Auxiliary) Jack. Schematic Diagrams
Circuit Diagram ...

See also:

Tail Gate Trim. Components and Components Location
Component Location 1. Tail gate trim ...

Tire Pressure Monitoring System (TPMS)
(1) TPMS malfunction indicator (2) Low tire pressure indicator (Shown on the LCD display) Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the recommended ...

Trailing Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...