Hyundai Santa Fe (DM): Description and Operation - Windshield Deicer - Body Electrical SystemHyundai Santa Fe (DM): Description and Operation

Description

Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an input signal from the front defroster switch, then controls relay.
When the front defroster switch is switched ON, and the engine is running with generator output, the deicer will go ON for a maximum of 20 minutes.

Components and Components Location
Component Location 1. Windshield deicer relay (Built-in engine room relay box) 2. Windshield deicer switch (Dual type) 3. Windshield deicer switch (Manual type) 4. Windshield deiecr 5. Deicer connector ...

Repair procedures
Inspection 1. Remove the cowl top cover. 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition ...

See also:

Starter Relay. Repair procedures
Inspection 1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay(A). 4. Using an ohmmeter, check that there is continuity between each terminal. Terminal ...

Instrument Cluster. Description and Operation
Description Communication Network Diagram Abbreviation Explanation C_CAN Chassis Controller Area Network B_CAN Body Controller Area Network MM_CAN Multi media Controller Area Network SMK Smart Key ECU ...

General Information. Repair procedures
Compression Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop engine. Allow the engine to warm up ...