Hyundai Santa Fe: Drive Belt. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Engine Mechanical System / Timing System / Drive Belt. Repair procedures

Removal and Installation

1.	For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A).

Install the drive belt (A).

Rotate the drive belt tensioner arm (A) counterclockwise moving the tensioner pulley bolt with wrench. After putting the belt on the tensioner pulley, release the tensioner pulley slowly.

Crankshaft pulley → A/C pulley → Alternator pulley → Idler #1 pulley → Idler #2 pulley → Water pump pulley → Tensioner pulley.

Inspection

Visually check the belt for excessive wear, frayed cords etc.

If any defect has been found, replace the drive belt.

Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Components and Components Location

Components 1. Intake camshaft 2. Exhaust camshaft 3. Intake CVVT assembly 4. Exhaust CVVT assembly 5. Timing chain 6. Timing chain guide 7. Timing chain tensioner arm 8. Timing chain tensioner 9. Timing ...

Idler. Repair procedures

Removal and Installation 1. Remove the drive belt. 2. Remove the idler(A). Tightening torque : 53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft) Check the idler. if it is grease leak or abnormal rotation, ...