Hyundai Santa Fe: Idler. Repair procedures - Timing System - Engine Mechanical SystemHyundai Santa Fe: Idler. Repair procedures

Removal and Installation

1.
Remove the drive belt.
2.
Remove the idler(A).
Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Check the idler. if it is grease leak or abnormal rotation, replace the idler.
3.
Install in the reverse order of removal.

Drive Belt. Repair procedures
Removal and Installation 1. For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A). 2. Install the drive belt (A). Rotate the drive belt tensioner arm (A) ...

Drive Belt Tensioner. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the drive belt auto tensioner(A). Tightening torque : 53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft) Tensioner pulley bolt is left-hands ...

See also:

Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...

Weight of the trailer tongue
The tongue load of any trailer is an important weight to measure because it affects the total gross vehicle weight (GVW) of your vehicle. This weight includes the curb weight of the vehicle, any cargo ...

Alternator. Schematic Diagrams
Circuit Diagram ...