Hyundai Santa Fe: Drive Belt Tensioner. Repair procedures - Timing System - Engine Mechanical SystemHyundai Santa Fe: Drive Belt Tensioner. Repair procedures

Removal and Installation

1.
Remove the drive belt.
2.
Remove the drive belt auto tensioner(A).
Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Tensioner pulley bolt is left-hands screw.
3.
Remove the drive belt tensioner (A).
Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

4.
Install in the reverse order of removal.

Idler. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the idler(A). Tightening torque : 53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft) Check the idler. if it is grease leak or abnormal rotation, ...

Crankshaft Damper Pulley. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the passenger engine room side cover. 3. Remove the passenger front tire. 4. Remove the crankshaft damper pulley(A). Tightening torque : 166.6 ...

See also:

Hood Latch Release Handle. Repair procedures
Replacement 1. Using a screwdriver or remover, remove the hood release handle (A). • Use a 6mm hex bit to press the center until the handle easily pulls off the post. 2. Install in the reverse order ...

Tilting the sunroof
When the sunshade is closed If you push the sunroof control lever upward, the sunshade will slide halfway open then the sunroof glass will tilt. To stop the sunroof movement at any point, pull or push ...

Front Alignment. Repair procedures
Front wheel alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels ...