Driveshaft and axleHyundai Santa Fe (TM): Driveshaft and axle

4WD Control System
Repair procedures Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the ...

Specifications
Specification Items Inner side Outer side Front driveshaft Joint type HLSJ#104 BJ#104C Max. permissible angle 23° 45° Rear driveshaft Joint type CJ#79 Max. permissible angle 23° Rear differential Oil ...

See also:

Cooling System
Coolant. Repair procedures Refilling And Bleeding    • Never remove the reservoir tank cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping ...

Rear Differential Carrier. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...

Checking the engine oil level
Type A Type B 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for ...