Hyundai Santa Fe: Front Washer Motor. Repair procedures - Windshield Wiper/Washer - Body Electrical SystemHyundai Santa Fe: Front Washer Motor. Repair procedures

Inspection

Front and Rear Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Connect positive (+) battery cables to terminal 3 and negative (-) battery cables to terminal 1 respectively.
3.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
4.
If they are abnormal, replace the washer motor.
[Front & Rear washer]
No.
 Description
1
 Ground
2
 Windshield washer (+)
3
 Rear washer (+)

https://kran-edaks.ru ремонт мостовых и козловых кранов.

Washer Fluid Level Sensor Switch
1.
Disconnect the negative(-) battery terminal.
2.
Drain the washer fluid less than 650 cc.
3.
Check for continuity between the No. 1 and No.2 terminal in each float position.
There should be continuity when the float is down.
There should be no continuity when the float is up.
4.
If the continuity is not as specified, replace the washer fluid level switch

Removal

-
When servicing the washer pump, be careful not to damage the washer pump seal.
-
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper cover.
3.
Remove the washer hose and disconnect the washer motor connector and washer fluid level sensor connector.
4.
Remove the washer motor (A).
5.
Remove the washer reservoir after removing bolts (A).

Installation

1.
Reassemble the washer reservoir.
Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.
2.
Connect the washer motor connector and washer hose.
3.
Install the washer reservoir.
Tightening torque (Bolt)
3.9 ~ 5.9 Nm (0.4 ~ 0.6 kgf.m, 2.9 ~4.3 lbf.ft)
4.
Reassemble the front bumper cover.

Front Wiper Motor. Repair procedures
Removal 1. Loosen the windshield wiper arm nut after removing a wiper cap (A). 2. Remove the windshield wiper arm and blade (B) 3. If necessary, release the wiper blade fixing clip by pulling up and remove ...

Rear Wiper/Washer
...

See also:

Crankshaft Damper Pulley. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the passenger engine room side cover. 3. Remove the passenger front tire. 4. Remove the crankshaft damper pulley(A). Tightening torque : 166.6 ...

Front Seat Shield Outer Cover. Components and Components Location
Component Location 1. Front seat shield outer cover ...

TPMS Receiver. Repair procedures
Adjustment 1. Disconnect the negative (-) battery cable. 2. Remove the glove box housing. 3. Disconnect the connector. 4. Remove the bracket (B) and receiver (C) as loosen the nut (A-1ea). Tightening torque ...