Hyundai Santa Fe: Front Wheel Repair procedures - Transfer Assembly - 4 Wheel Drive (4WD) SystemHyundai Santa Fe: Front Wheel Repair procedures

Removal

1.
Remove the driveshaft and axle.
2.
Remove the propeller shaft (A).
Tightening torque :
49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft)

3.
Loosen the transfer upper & lower mounting bolts. (transfer side → transaxle side)
4.
Loosen the transfer lower mounting blot. (transaxle side → transfer side)

Installation

1.
Install in the reverse order of removal.
1.
Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
2.
Smear and cover splines (B) with molybdenum type high pressure grease.
TECHLUBE MEGAMAX - ALPHA OR EQUIVALENT

3.
Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.

Front Wheel Components and Components Location
Components Location 1.Under cover 2. Transaxle Assembly 3. Transfer assembly 4. Propeller shaft 5. Coupling assembly ...

Oil Seal. Repair procedures
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). 4. Install the oil seal with special service tools. • Apply lithium ...

See also:

Rear Pillar Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

To defog inside windshield
1. Select desired temperature. 2. Select desired fan speed. 3. Press the defrost button (). 4. The outside (fresh) air position will be selected automatically. If the outside (fresh) air position is not ...

Forward and rearward
To move the seat forward or rearward: 1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked in place. ...