Hyundai Santa Fe: General Information
ICM (Integrated Circuit Module)
Relay Box. Repair procedures DBC Switch. Repair procedures Engine Control Module (ECM). Repair procedures
Specifications Tightening Torques Items N.m Kgf.m lb-ft Transfer assembly mounting bolts 60.8~65.7 6.2~6.7 44.8~48.5 4WD ECM mounting nuts 9.8~11.8 1.0~1.2 7.2~8.7 Coupling assembly mounting bolts 56.9~64.7 ...
SpecificationsSee also:
Inspection Rear Blower Motor relay Check for continuity between the terminals. 1. There should be continuity between the No.16 and No.15 terminals when power and ground are connected to the No.13 and No.14 ...
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the crash pad side switch assembly (A) after loosening the screws. 4. ...
Removal When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with ...
