Hyundai Santa Fe: General Information. Special Service Tools
Special Service Tools
|
Tool (Number and name) |
Illustration |
Use |
|
Crankshaft front oil seal installer (09214-3K000) (09231-H1100) |
|
Installation of the front oil seal A : 09214-3K000 (installer) B : 09231-H1100 (handle) |
|
Valve stem seal installer (09222-4A000) |
|
Installation of the valve stem oil seal |
|
Valve spring compressor (09222-3K000) (09222-3K100) |
|
Removal and installation of the intake or exhaust valve A : 09222-3K000 (compressor) B : 09222-3K100 (holder) |
|
Crankshaft rear oil seal installer (09214-3K100) (09231-H1100) |
|
Installation of the crankshaft rear oil seal A : 09214-3K100 (installer) B : 09231-H1100 (handle) |
|
Ring gear stopper (09231-3K000) |
|
Removal and installation of crankshaft pulley bolt. |
|
Ring gear stopper (09231-3D100) |
|
Removal and installation of crankshaft pulley bolt. |
|
Torque angle adapter (09221-4A000) |
|
Installation of bolts & nuts needing an angular method
of adjustment. |
|
Oil pan remover (09215-3C000) |
|
Removal of oil pan |
|
Oxygen sensor socket wrench (09392-2H100) |
|
Removal and installation of oxygen sensor |
|
Oil filter wrench (09263-2E000) |
|
Removal and installation of oil filter |
General Information. Troubleshooting
Troubleshooting Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywheel Replace the crankshaft and ...
See also:
Front seat adjustment - Power
The front seat can be adjusted by using the control knobs located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, ...
Mode selection
The mode selection button controls the direction of the air flow through the ventilation system. Face-Level (B, D, F) Air flow is directed toward the upper body and face. Additionally, each outlet can ...
Lumbar support (for driver’s seat)
1. Press the front portion of the switch to increase support or the rear portion of the switch to decrease support. 2. Release the switch once it reaches the desired position. ...
